EKOP180E Mobile Phone User Manual EKO Pocket -0615 Interglobe Connection

Interglobe Connection Mobile Phone

Alternate Views: PDF [Zoom] Download [PDF]

EKO                 Pocket P180




       Pocket P180
      USER MANUAL




           Page 1


EKO                                                                                     Pocket P180
           Know Your Phone




OK KEY                Enter into the main menu, Long press to on/off the torch.

Left soft key         Enter main menu in idle mode.
                      Press left soft key, then press * to lock/unlock the key pad

Dial key              Dial and receive a call. View All calls in the standby mode.

Number keys           Enter numbers, letters or characters.

* key                 Press to select punctuations when writing message

Right soft key        Access the Contacts list menu in idle mode. Return to previous menu.

Call end key          Pressing and holding to turn the phone on/off.
                      End a call or reject an incoming call. Return to the idle mode.

Navigation keys       Press to access four functions in idle mode Up —— Camera, Down —— Audio player
                      Right —— Calendar, Left —— Write message

# key                   Press to switch input modes when writing message.



                                                 Page 2


EKO                                                                   Pocket P180
  Batteries
  The battery is included in the package. It is not fully charged out of factory but it may
  still be able to power on your phone. Please completely use up the power of the
  battery and then charge it for at least 12 hours with your phone turned off. You
  battery will reach its optimal state after three cycles of charge and discharge.


  Installing and uninstalling the battery
  To install the battery, remove the back cover from the phone by pressing firmly on
  the cover and slide it down. Align the golden contacts of the battery to the contacts
  in the phone, and then gently snap down the battery into place. Re‐assemble the
  back cover.


  To uninstall the battery, flip the battery out from the bottom of the battery.


  Charging the battery
  Plug the charger into the socket on the side of your phone. Connect the charger to an
  AC wall socket. The blinking of the battery level icon indicates the battery is being
  charged. When the blinking stops, it indicates the charging is finished


  During charging, the phone and charger will feel warm to the touch. This is normal.
  Warning:
  The operating ambient temperature of the charger is 0 C‐50         C. Do not use it when
  the temperature exceeds this limit.
  Use only chargers approved by the phone manufacturer to ensure safety. Failing to
  comply with this will violate the terms and conditions of the warranty.


  Using the battery
  The waiting time and calling time capacities specified by the phone manufacturer are
  obtained under the ideal operating environment. The actual values will vary with the
  network condition, operating environment and operation method.


  Please comply with the local regulations of disposing the battery (such as recycling).
  Do not dispose it as household waste.

                                       Page 3


EKO                                                                  Pocket P180

  Battery level indicator
  When the phone is on, the battery level indicator is located at the upper right corner
  of the screen.




  Connecting to the Network


  SIM card
  Please insert available Subscriber Identity Module (SIM) card into your phone before
  using it. SIM card is supplied by your network carrier.


  All the information related to network connection is recorded on the SIM card, so are
  the contact information such as names, phone numbers and SMS that you set to
  store on the SIM. You can take out the SIM card from the phone and insert it into
  another GSM phone to use it. Most new phones will recognize the SIM card
  automatically.


  Do not touch the golden contacts of the SIM card and place it away from electricity
  and magnetism to avoid damage. You will not be able to use the phone if the SIM
  card is damaged.


  Note:
  Before inserting and taking out the SIM card, always make sure that the phone is
  switched off and disconnected from any external power source; otherwise both the
  phone and the SIM card may be damaged.


  Installing and uninstalling the SIM card
  The SIM card usually comes attached to a special card. The metal contacts of SIM
  card is easily damaged by scratching, so take it out carefully before assembling it into
  the phone.


  Switch off the phone; remove the back cover, battery and other external power
                                      Page 4


EKO                                                                     Pocket P180
  source. Fit the SIM card into the SIM card slot. Align the angled corner of the SIM
  card with the slot. Slide in the SIM card, make sure it is in place, install the battery,
  and restore the back cover.


  Likewise, to remove the SIM card, switch off the phone, remove the battery and then
  take out the SIM card.


  Unlock the SIM card
  PIN code
  Your Personal Identification Number (PIN/PIN2) code protects the SIM card against
  unauthorized use. Your PIN/PIN2 code is usually supplied with the SIM card. If this
  security function is enabled, you need to enter the PIN/PIN2 code every time you
  turn on the phone. You can also disable this function.


  To unlock the SIM card, press and hold the power button to turn on the phone. Enter
  the PIN/PIN2 code. After three consecutive incorrect PIN/PIN2 code entries, the code
  is blocked, and you need the PUK code to unblock it.


  PUK code
  This code is required to change a locked PIN code. If the code is not supplied with the
  SIM card, contact your service provider. After ten consecutive incorrect PUK code
  entries, the SIM card cannot be used any more. Please contact your service provider
  to buy a new SIM card. You cannot edit PUK code. If it is lost, Please contact your
  service provider.


  Connecting to the network
  After the SIM card is unlocked, you phone will automatically search for the registered
  network or other local available network. Once connected, the name of the network
  carrier will appear on the top of the screen.


  You phone is now in Standby mode, ready for making and receiving calls.




                                        Page 5


EKO                                                                         Pocket P180
     Basic Operations

        Switch Phone ON/OFF
        To switch ON/OFF your phone, press and hold the End key for a few seconds.

        Unlock the phone
        If you do not use the phone for a while, the screen is replaced with a locked
        screen.
      1. Press any key to activate the screen.
      2. Press Unlock key, and then press * key.


        Make a call
        You can make a call in the following ways:
        Enter the desired number in standby mode and press the Call key to
          make the call.
        Go to Menu > Phonebook and then select and dial the desired number.
        Just press the Call key to dial the contacts listed in Call logs.
        You can also dial a contact from the messages.


      Notable Features

        Secure your Phone
    Menu > Settings > Security settings> Phone security
    Let you lock/unlock your phone via a security password which you can change
    anytime.
    The default security code to unlock the phone is 1234.
    Note: After you activate the phone lock, you would be asked for a password when you
    power on your phone next time.


【Phone settings】

【Display】


                                          Page 6


EKO                                                                      Pocket P180
[Animation effect]: Set the power on/off animation

[Wallpaper settings] Set wallpaper

[Idle display setting] Set the idle

[Contrast] adjust the screen's backlight brightness

[Backlight] Set the backlight time screen

[Keypad backlight time] Set the backlight time key

【Security】

[PIN] Select open or modify the phone's PIN code

[Modify PIN2] PIN2 choose to modify the phone code

[Phone locked]: Set the phone locked

[Change phone password]: Modify the password of phone

[Date security] set access to enter the password to view functionality. (Including: call logs /

message / camera / phonebook / my files / ebook / calendar / Mass storage /audio

player/video player)

[Auto keypad lock] Set the auto keypad lock

[Lock screen by end‐key] press the end key to select whether the off‐screen function




                                            Page 7


EKO                                                                       Pocket P180
  Disclaimers

   1.   The colors and specifications shown/mentioned in the user manual may differ
        from the actual product. Images shown are for representation purpose only. Other
        product logos and company names mentioned herein may be trademarks or trade
        names of their respective owners.
   2.   EKO keeps the right to make modifications to any of the content in this user guide
        without public announcement in advance. The content of this manual may vary
        from the actual content displayed in the mobile phone. In such a case, the latter
        shall govern.
   3.   Upon first use of the device it will send information related to model, mobile
        number, IMEI numbers, Operator, Circle through an SMS. This One time SMS will
        be charged as per Operator tariff.

  Copyrights
        All rights reserved. Reproduction, transfer, distribution or storage of part or all of
        the contents in this document in any form without the prior written permission of
        EKO is strictly prohibited.

FCC Warning:

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and
                                          Page 8


EKO                                                                    Pocket P180
used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.



SAR tests are conducted using standard operating positions accepted by the FCC with the

device transmitting at its highest certified power level in all tested frequency bands,

although the SAR is determined at the highest certified power level, the actual SAR level of

the device while operating can be well below the maximum value, in general, the closer

you are to a wireless base station antenna, the lower the power output.

Before a new device is a available for sale to the public, it must be tested and certified to

the FCC that it does not exceed the exposure limit established by the FCC, Tests for each

device are performed in positions and locations as required by the FCC.

For body worn operation, this device has been tested and meets the FCC RF exposure
                                         Page 9


EKO                                                                   Pocket P180
guidelines when used with an accessory designated for this product or when used with an

accessory that contains no metal and that positions the handset a minimum of 5 mm from

the body.

Non‐compliance with the above restrictions may result in violation of RF exposure
guidelines.




                                       Page 10



Document Created: 2019-03-24 03:14:53
Document Modified: 2019-03-24 03:14:53
Download: EKOP180E Mobile Phone User Manual EKO Pocket -0615 Interglobe Connection
Mirror Download [FCC.gov]EKOP180E Mobile Phone User Manual EKO Pocket -0615 Interglobe Connection
Document ID3985064
Application IDm092d1zBMe5SS8pchPdKhA==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize19.29kB (241075 bits)
Date Submitted2018-08-30 00:00:00
Date Available2018-10-14 00:00:00
Creation Date2018-08-21 17:36:49
Producing SoftwareAcrobat Distiller 9.0.0 (Windows)
Document Lastmod2018-08-30 10:36:15
Document TitleEKO Pocket user manual-0615
Document CreatorPScript5.dll Version 5.2.2
Document Author: dg06080