UZB-7 Z-Wave Controller User Manual User Manaual CEx Silicon Laboratories

Silicon Laboratories Z-Wave Controller

Alternate Views: PDF [Zoom] Download [PDF]

EFR32ZG14 Zen Gecko
UZB-7 Z-Wave Controller USB Dongle
BRD1001A Datasheet

  The Silicon Labs UZB-7, Z-Wave Controller USB Dongle, is a simple    Key Features & Benefits
  reference design featuring the latest generation Z-Wave SoC,
\ Note 1 Note 1
  EFR32ZG14 Zen Gecko, as a gateway and controller in smart home
                                                                          Z-Wave 700 Series SoC EFR32ZG14
  application.
                                                                           Zen Gecko
 UZB-7 exposes the well-documented and proven Z-Wave Serial API           +6 dBm sensitivity improvement in
 via USB. It allows the host processor to control up to 232 Z-Wave         100kbps channels
 devices and Z-Wave Plus devices through Z-Wave protocol. With            Firmware upgradable through USB
 the developer PC application software, PC Controller, or any
                                                                          AES 128-bit encrypted
 software compliance with Z-Wave Serial API, the host is
                                                                           communication and security
 empowered to communicate with various Z-Wave devices through
                                                                           feature
 Z-Wave Command Classes, making your computer the heart of
 your Z-Wave network                                                      Compliance approval (tbc)
                                                                            EU      EN 300220
 With the benefits of Z/IP from Silicon Labs, controller software           US      FCC CFR47 Part 15.249
 base on Z/IP such as Z-Ware from Silicon Labs, enable you to create        ANZ     ANZ 4268
 your own Z-Wave gateway that is locally or remotely hosted.                Japan   ARID STD-T108
                                                                          Worldwide SAW filters for
 Z-Wave is an established short range interoperable two-way RF
                                                                           additional out-of-band blocking
 mesh network technology. Refer to http://www.z-wave.com for
                                                                           consideration
 the technology description, various Z-Wave Plus ready certified
 products, and Z-Wave Alliances                                           CP2102N USB-to-UART SoC for VCP
                                                                          USB 2.0 Full Speed Compliance
                                                                          Royalty-free Virtual COM port
                                                                           drivers, CP210x VCP Driver
                                                                          Work with Windows / Mac / Linux




silabs.com | Building a more connected world.                                                              Rev 0.30


                                                                                                   UZB-7 Z-Wave Controller
                                                                                                           User Manual




                                                                           Product Specification

 General Specification                                                     Z-Wave Libraries
 ERF32ZG14 Zen Gecko SoC                                                   Z-Wave Library     Bridge Controller
 USB powered                             5.00 ± 0.25V                      Z/IP Application   Version 5.64
 RF Transmit current                     22 mA (typ.)                      Z-Wave DLL         Version 5.64
 RF Receive current                      20 mA (typ.)
 RF Transmit power *1                    Up to +13 dBm (max.)              Ordering Information
 RF Sensitivity                                                            SLUSB7000A         UZB-7 Z-Wave Controller
         9.6 kbps                        101 dBm (typ.)
         40 kbps                         100 dBm (typ.)
         100 kbps                        97 dBm (typ.)
 Operating Temperature                   -15 to 55˚C
 Internal antenna                        PCB antenna
 Sleep current * 2                       < 25uA
 Range* 1                                > 40 m open space line-of-sight


 Note* 1 Allowable transmit power are governed by respective regulatory
 Note* 2 UZB-7 is typically always active




 Block diagram




 Refer to [1] UZB-7 Reference Manual for further descriptions of each blocks, and design considerations and options for
 UZB-7.




silabs.com | Building a more connected world.                                                                 Rev 0.30


                                                                                                           UZB-7 Z-Wave Controller
                                                                                                                    User Manual


Frequency Allocation
                                                    Table 1. Frequencies Allocation

  Region                                 US                EU              Australia            Japan              Korea
                                                                          New Zealand
  Model                                                                     UZB-7
  Firmware                                                               Z-Wave 7.00
  Data Rate                                     9.6 kbps / 40 kbps / 100 kbps                           100 kbps
  Number of Channels                                                            2/3
  Frequency                         908.42 MHz        868.42 MHz          921.42 MHz         922.50 MHz       920.90 MHz
                                    908.40 MHz        868.40 MHz          921.40 MHz         923.90 MHz       923.90 MHz
                                    916.00 MHz        869.85 MHz          919.80 MHz         926.30 MHz       926.30 MHz
  Max. Power                           -1 dBm            13 dBm             12 dBm              0dBm               13dBm


Quick Start Up
Here is a Quick Start Up guide to get UZB-7 to work with Z-Wave PC Controller. The Z-Wave PC Controller is a PC
application software tool enable communications to Z-Wave nodes such as switches and sensors.
    1. Connect UZB-7 to your computer
    2. Install the Virtual COM Port (VCP) drivers UZB-7, CP201x UART-to-USB Driver, CP210x VCP Driver.
       The latest drivers are available at www.silabs.com/interface-software.
    3. Install and Run Z-Wave PC Controller from Simplicity Studio




    4. Click on the “Setting-wheel”             on Right-Top corner of PC Controller and select “Silicon Labs CP210x USB to
       UART Bridge”. Click OK




silabs.com | Building a more connected world.                                                                         Rev 0.30


                                                                                                 UZB-7 Z-Wave Controller
                                                                                                         User Manual




    5. Click on Next Work Management




    6. UZB-7 is detected and appears as [S2] Pc Controller. The bottom panel display information and Z-Wave
       Command Class supported by UZB-7.




    7. From here, you can perform basic commands to end devices. Refer to [3] PC Controller User Guide for more
       info.

silabs.com | Building a more connected world.                                                                 Rev 0.30


                                                                                                      UZB-7 Z-Wave Controller
                                                                                                              User Manual



EU Declaration of Conformity
This device complies with Radio Equipment Directive 2014/53/EU issued by the Commission of the European
Community. The following test methods have been applied to prove presumption of conformity with the essential
requirement of the directive.

EN 300 220-1: V3.1.1(2017-02)
EN 300 220-2: V3.1.1 (2017-02)
EN 301 489-1: V2.1.1 (2017-02)
Final draft EN 301 489-3: V2.1.1 (2017-03)
EN 62311:2008
EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013


FCC Federal Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
        Reorient or relocate the receiving antenna.
        Increase the separation between the equipment and receiver.
        Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
        Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.




silabs.com | Building a more connected world.                                                                    Rev 0.30


                                                                                                  UZB-7 Z-Wave Controller
                                                                                                          User Manual



Document Revision History
Revision 0.30      2019-01-05          Beta-2 document revision




Contacts
Silicon Labs                           400 West Cesar Chavez, Austin TX78701 USA
Silicon Labs International             18 Tai Seng, #05-01 18 Tai Seng Street, Singapore 539775
Silicon Labs Denmark                   Emdrupvej 28B, 2100 Copenhagen Denmark
Silicon Labs Norway                    Sandakerveien 118 0484 Oslo Norway




silabs.com | Building a more connected world.                                                                Rev 0.30


                                                    Silicon Labs


                                                   Simplicity Studio4

                                                             "Whee
                                                            (e==

                                                     Tz
                                                          ._a‘~




     Simplicity Studio
     One—click access to MCU and
     wireless tools, documentation,
     software, source code libraries &
     more. Available for Windows,
     Mac and Linux!




                lo? Portfolio                                        Bubld                                          Quality                               Support and Community
             eceocuidn                                     www.silabs.com/simplicity                        www.silabs.com/quality                            community.silabs.com



Disclaimer
Silicon Labs intends to provide customers with the latest, accurate, and in—depth documentation of all peripherals and modules available for system and software implementers using or
intending to use the Silicon Labs products. Characterization data, available modules and peripherals, memory sizes and memory addresses refer to each specific device, and "Typical"
parameters provided can and do vary in different applications. Application examples described herein are for illustrative purposes only. Silicon Labs reserves the right to make changes
without further notice and limitation to product information, specifications, and descriptions herein, and does not give warranties as to the accuracy or completeness of the included
information. Silicon Labs shall have no liability for the consequences of use of the information supplied herein. This document does not imply or express copyright licenses granted
hereunder to design or fabricate any integrated circuits. The products are not designed or authorized to be used within any Life Support System without the specific written consent of
Silicon Labs. A "Life Support System" is any product or system intended to support or sustain life and/or health, which, if it fails, can be reasonably expected to result in significant personal
injury or death. Silicon Labs products are not designed or authorized for military applications. Silicon Labs products shall under no circumstances be used in weapons of mass
destruction including (but not limited to) nuclear, biological or chemical weapons, or missiles capable of delivering such weapons.

Trademark Information
Silicon Laboratories Inc.® , Silicon Laboratories®, Silicon Labs®, SiLabs® and the Silicon Labs logo®, Bluegiga®, Bluegiga Logo®, Clockbuilder®, CMEMS®, DSPLL®, EFM®, EFM32®,
EFR, Ember®, Energy Micro, Energy Micro logo and combinations thereof, "the world‘s most energy friendly microcontrollers", Ember®, EZLink®, EZRadio®, EZRadioPRO®,
Gecko®, ISOmodem®, Micrium, Precision32®, ProSLIC®, Simplicity Studio®, SiPHY®, Telegesis, the Telegesis Logo®, USBXpress®, Zentri, Z—Wave, and others are trademarks or
registered trademarks of Silicon Labs. ARM, CORTEX, Cortex—M3 and THUMB are trademarks or registered trademarks of ARM Holdings. Keil is a registered trademark of ARM
Limited. All other products or brand names mentioned herein are trademarks of their respective holders.


                                           ®
                             mes                      Silicon Laboratories Inc.
                         —                            400 West Cesar Chavez
                a               j    4                Austin, TX 78701
                                                      USA


  SILICON LABS                                         http:/www.silabs.com


  BRD1001A Reference Manual
Document Revision History



Document Created: 2019-01-28 10:43:30
Document Modified: 2019-01-28 10:43:30
Download: UZB-7 Z-Wave Controller User Manual User Manaual CEx Silicon Laboratories
Mirror Download [FCC.gov]UZB-7 Z-Wave Controller User Manual User Manaual CEx Silicon Laboratories
Document ID4147020
Application IDdrRpWM8JsHYTHOtgub2tag==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeYes
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize131.46kB (1643286 bits)
Date Submitted2019-01-25 00:00:00
Date Available2019-01-31 00:00:00
Creation Date2019-01-23 16:39:24
Producing SoftwareMicrosoft: Print To PDF
Document Lastmod2019-01-28 10:43:30
Document TitleUser Manaual CEx
Document CreatorNone
Document Author: gequat