CODA4782 DOCSIS 3.1 wifi Gateway User Manual Users Manual Hitron Technologies Inc.
Hitron Technologies Inc. DOCSIS 3.1 wifi Gateway
FCC ID >
FCC ID Filing: 2AHKM-CODA4782
Purchase on Amazon: DOCSIS 3.1 wifi Gateway
QUICK START GUIDE HITRON CODA-4582/ 4682/ 4782 Check the Box Contents STEP Read me Look in the box and make sure you have the following: first! CODA-4582/ 4682/ 4782 Connect to the network Set up your wireless network Connect to a Cable Outlet STEP Use a coaxial cable (not included) to connect the device’ s CABLE connector to a cable outlet. Connect to an Ethernet-Equipped Device (Optional) STEP Use the Ethernet cable provided to connect one of the LAN ports to an Ethernet-equipped device. POWER CORD ETHERNET CABLE QUICK START GUIDE The Hitron CODA-4582/ 4682/ 4782 is an application gateway that provides wired and wireless high-speed Internet access as well as optional MoCA (Multimedia over Coax Alliance) networking to the Ethernet-enabled devices in your home for a fast and easy home entertainment network. Connect to a Power Outlet STEP Use the power cord provided to connect the POWER port to a power outlet. User Configuration (Optional) STEP In a web browser, enter 192.168.0.1 in the address bar followed by Username and Password, as below. c usa dm in pa ssw ord Connect with Wireless Devices (Optional) STEP Connect your wireless devices with the correct SSID and Passphrase. If you have not changed them, the default values are indicated on the sticker on the back of the unit. Connect your wireless devices with the WiFi Protected Setup (WPS). Access the configuration interface (see step 5), enter the Wireless page to enable WPS and set Encrypt Mode to AES, then press Save Changes. Press this button to begin the WPS Push-Button Configuration (PBC) procedure. Press the PBC button on your wireless clients in the coverage area within two minutes to enable them to j oin the wireless network. Setup Complete STEP Congrat ulat ions! You have successfully set up your CODA-4582/ 4682/ 4782. If you have any problems, see t he sect ion below for help in ident ifying t he cause. IP Addresses If t he CODA-4582 is successfully connect ed t o t he net work (see LED Display) but you cannot access t he Int ernet from a connect ed comput er, your comput er’ s IP Address may be set up improperly. In your comput er’ s net work set t ings, ensure t hat it is configured t o eit her receive an IP address aut omat ically (recommended) or t hat it has a st at ic IP address in t he 192.168.0.10~192.168.0.254 range. For more informat ion, consult your operat ing syst em’ s Help document at ion. LED Display Green-St eady Device is running wit h AC power. Of f Not powered. Green-Blinking is being t ransmit t ed or received. Power Green-Blinking The modem is searching f or t he downst ream Wireless (2.4GHz) Green-St eady The 2. 4GHz wireless net work is enabled, and no dat a is being t ransmit t ed or received. f requency. Downsteam Connec Green-St eady t powerBlue-St eady The 2. 4GHz wireless net work is enabled, and dat a Of f Downst ream f requency is locked. (1 channel only) The 2. 4GHz wireless net work is not enabled. Downst ream f requency is locked. (channel bonding) Green-Blinking The 5GHz wireless net work is enabled, and dat a is Cyan-St eady DOCSIS 3. 1 OFDM Of f Not scanning being t ransmit t ed or received. Wireless (5GHz) Green-St eady The 5GHz wireless net work is enabled, and no Green-Blinking The modem is searching f or t he upst ream dat a is being t ransmit t ed or received. f requency. Of f Upsteam Green-St eady Upst ream f requency is locked. (1 channel only) Blue-St eady Upst ream f requency is locked. (channel bonding) Cyan-St eady DOCSIS 3. 1 Of f Not scanning The 5GHz wireless net work is not enabled. Green-Blinking Gat eway is searching f or MoCA device. Green-St eady MoCA (Optional) MoCA device has been det ect ed, and t he CODA-4582/ 4682/ 4782 has successf ully made a Green-Blinking Regist rat ion is in progress wit h cable company’s connect ion. head-end. Of f Online Green-St eady Gat eway is operat ional f or dat a t ransmission. Of f Gat eway is of f line. MoCA f unct ion is not enabled. Green-Blinking USB device is plug-in USB port . Green-Blinking Et hernet is act ivat ed. Of f Of f Et hernet is disabled. No USB device. USB Ethernet Safety Warnings WARNING Risk of elect rical shock. Do not expose t he device t o wat er or moist ure. The device is a high-performance communicat ions device designed for home and office environment s. Do not use t he device out doors. Keep t he device in an environment bet ween 0° C ~ 40° C (32° F ~104° F). To avoid overheat ing, do NOT place any obj ect on t op of t he device. Do not rest rict t he flow of air around t he cable modem. The manufact urer assumes no liabilit ies for damage caused by any improper use of t he device. DISCLAIMER The manufact urer assumes no liabilit ies wit h respect t o t he cont ent s of t his document . The manufact urer also reserves t he right t o revise t his document or updat e t he cont ent t hereof wit hout any obligat ion t o not ify any person of such revisions or amendment s. Specificat ions subj ect t o change wit hout not ice. CAUTION The cable dist ribut ion syst em should be grounded (eart hed) in a accordance wit h ANS/ NFPA 70, t he Nat ional Elect rical Code (NEC), in part icular Sect ion 820.93, Grounding of Out er Conduct ive Shield of a Coaxial Cable. FCC Statement: Federal Communication Commission Interference Statement This equipment has been t est ed and found t o comply wit h t he limit s for a Class B digit al device, pursuant t o Part 15 of t he FCC Rules. These limit s are designed t o provide reasonable prot ect ion against harmful int erference in a resident ial inst allat ion. This equipment generat es, uses and can radiat e radio frequency energy and, if not inst alled and used in accordance wit h t he inst ruct ions, may cause harmful int erference t o radio communicat ions. However, t here is no guarant ee t hat int erference will not occur in a part icular inst allat ion. If t his equipment does cause harmful int erference t o radio or t elevision recept ion, which can be det ermined by t urning t he equipment off and on, t he user is encouraged t o t ry t o correct t he int erference by one of t he following measures: ● ● ● ● Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caut ion: Any changes or modificat ions not expressly approved by t he part y responsible for compliance could void t he user’ s aut horit y t o operat e t his equipment . This device is going t o be operat ed in 5.15~5.25GHz frequency range, it is rest rict ed in indoor environment only. This device complies wit h Part 15 of t he FCC Rules. Operat ion is subj ect t o t he following t wo condit ions: (1) This device may not cause harmful int erference, and (2) t his device must accept any int erference received, including int erference t hat may cause undesired operat ion. For product available in t he USA/ Canada market , only channel 1~11 can be operat ed. Select ion of ot her channels is not possible. This device and it 's ant ennas(s) must not be co-locat ed or operat ing in conj unct ion wit h any ot her ant enna or t ransmit t er except in accordance wit h FCC mult i-t ransmit t er product procedures. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies wit h FCC radiat ion exposure limit s set fort h for an uncont rolled environment . This equipment should be inst alled and operat ed wit h minimum dist ance 21cm bet ween t he radiat or & your body. IC Statement: This device complies wit h Indust ry Canada license-exempt RSS st andard(s). Operat ion is subj ect t o t he following t wo condit ions: (1) t his device may not cause int erference, and (2) t his device must accept any int erference, including int erference t hat may cause undesired operat ion of t he device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. For product available in t he USA/ Canada market , only channel 1~11 can be operat ed. Select ion of ot her channels is not possible. Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas possible. This device and it 's ant ennas(s) must not be co-locat ed or operat ing in conj unct ion wit h any ot her ant enna or t ransmit t er except in accordance wit h IC mult i-t ransmit t er product procedures. Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur. The device for t he band 5150-5250 MHz is only for indoor usage t o reduce pot ent ial for harmful int erference t o co-channel mobile sat ellit e syst ems. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux. IC Radiation Exposure Statement: This equipment complies wit h IC RSS-102 radiat ion exposure limit s set fort h for an uncont rolled environment . This equipment should be inst alled and operat ed wit h minimum dist ance 21cm bet ween t he radiat or & your body. Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 21 cm de distance entre la source de rayonnement et votre corps. COPYRIGHT © 2016 HITRON TECHNOLOGIES, INC. 0440010241N0
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Page Count : 1 XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6 About : uuid:58327122-a802-11f2-0000-02c7314339d4 Producer : GPL Ghostscript 9.18 Modify Date : 2017:07:23 20:30:41Z Create Date : 2017:07:23 20:30:41Z Creator Tool : UnknownApplication Document ID : uuid:58327122-a802-11f2-0000-02c7314339d4 Format : application/pdf Title : UntitledEXIF Metadata provided by EXIF.tools