T1R1UNV210P60W LED Driver User Manual æœªå‘½å -1 Fulham Electronic Co., Ltd
Fulham Electronic Co., Ltd LED Driver
IP65 T1R1UNV210P-60C INSTALLATIONS • • • • Built-in LED Driver U-OUT 60V IP 65 Dry and Damp Suitable for Class I luminaire • • • • Universal Voltage:120-277V~,50/60Hz Output voltage range of 10-57V 100% - 1%, 0% • • E342838 Programmable LED Driver Wireless D imming Output Power: 60W Max. Output Current: 0.5-2.1A This Driver Will Operate The Following LED Modules: Any LED module designed to accept input voltage up to current of 0.5-2.1A. range of 10-57 VDC and can operate General Speciﬁcations Input Voltage Input Current Inrush Current Input Power NTC Input Power Factor THD Eﬃciency Driver Type Output Current 120-277V~, 50/60 Hz 0.6A Max. TBDA@277V 72W Ext. NTC Derating Resistence Range: 1k to 51k Ohm programmable. Default/Recommended Ext. NTC P/N: TSM2A104J4503RZ,SMD0805,Thinking Electronic. >0.95@Full Load <20% 85% Typical @Full Load Constant Current & Constant Power 0.5-2.1A Programmable;See Label For Set Current;To Program The Output Current Use R-SET Resistor.(Figure 1) or TPSB-100 (Setting Controller) ;Print & Record New Setting On 1"x0.5" Label; Factory default setting is to the lowest output current, unless custom FCC current setting is requested by customer. 10-57V 60W Max. 1 Channel Wireless/ 100%-1%,0% FCC Part 15B Consumer Class 2 Potting As Per ASTM D36-86 / Fully Potted -40°C to 60°C (-40°F to 140°F) 90°C (194°F) Line-Neutral 4kV, Line & Neutral-Ground 6kV Input Current Protection Output Short Circuit Protection Output Open Circuit Protection Output to Ground Short Protection Overload Protection Over Temperature Protection ID: 2AJ9LT1R1UNV210P60W Runtime Counting of Every 10 Degrees Service Life Approvals / Class Warranty Yes 50,000 hours @Tc 80°C (176°F) RoHS, UL LISTED ,CLASS P ,IP65,FCC,Dry and Damp 5 years Output Voltage Range Output Power Number of Output Channels Dimming Controller Type/Dimming Range RFI/EMI Output Type Potting Type / Degree of Fill Ambient Operating Temperature Range Max. Case Temperature Sound Rating Input Surge Protection Protections Fulham Head Quarters: Fulham Co., Inc 12705 South Van Ness Ave. Hawthorne, CA 90250 Local: (323) 779-2980, Fax: (323) 754-9060 Manufacturer: North China Fulham Electronic Co. Ltd. Fulham extends a limited warranty to the original purchaser or ﬁrstuser for aperiod of 5 years @ Tc 80°C from the date of manufacture when properly installed and operated under normal conditions of use. The usage of appropriate series connected Surge Protection Device (SPD) is required in high Speciﬁcations subject to change without risk applications.For complete terms and conditions, please refer to the Warranty Center at www.fulham.com. notice. 20180829-1 REV B IP65 T1R1UNV210P-60C INSTALLATIONS Mechanical Data E342838 100% - 1%, 0% 5.96"(151.4mm) 5.26"(133.6mm) HEIGHT LENGTH WIDTH 151.4mm 90mm 32mm 5.96" 3.54" 1.26" 4.8"(122mm) 0.18"( 4.5mm) 0.75"(19.1mm) 1.26"(32mm) 13"(330±12.7mm) 0.46"(11.8mm) BLACK WHITE 2.32"(59mm) 2.76"(70mm) 3.54"(90mm) 9.84"(250±12.7mm) ORANGE YELLOW RED BLUE 13"(330±12.7mm) Wiring Diagrams Tolerance=±0.02" Mounting the LEDdriver NOTE:This driver has four mounting holes,two on each side. Need to mount four round holes. Making the wire connections BLK(L) INPUT 120-277VAC LED DRIVER R-SET NTC OUTPUT WHT(N) INPUT SIDE BL ACK WHITE LENGTH 330mm [ 13" ] 330mm [ 13" ] ANT Programming Side ORG YLW ORANGE YELLOW RED BLUE LED MODULE OUTPUT SIDE RED BLUE LENGTH 250mm [ 9.84"] 250mm [ 9.84"] LENGTH 330mm [ 13" ] 330mm [ 13" ] INPUT 120-277V~ LED MODULE Ø (0.75-1.5)mm² 18AWG 11mm Fulham extends a limited warranty to the original purchaser or ﬁrstuser for aperiod of 5 years @ Tc 80°C from the date of manufacture when properly installed and operated under normal conditions of use. The usage of appropriate series connected Surge Protection Device (SPD) is required in high Speciﬁcations subject to change without risk applications.For complete terms and conditions, please refer to the Warranty Center at www.fulham.com. notice. 20180829-2 REV B IP65 T1R1UNV210P-60C INSTALLATIONS 100% - 1%, 0% E342838 Wireless Dimming Steps Fulham extends a limited warranty to the original purchaser or ﬁrstuser for aperiod of 5 years @ Tc 80°C from the date of manufacture when properly installed and operated under normal conditions of use. The usage of appropriate series connected Surge Protection Device (SPD) is required in high Speciﬁcations subject to change without risk applications.For complete terms and conditions, please refer to the Warranty Center at www.fulham.com. notice. 20180829-3 REV B FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.
Source Exif Data [exif.tools]:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Author : MZG Create Date : 2018:11:21 09:44:18+08:00 Modify Date : 2018:12:28 14:09:04-08:00 Has XFA : No XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Format : application/pdf Creator : MZG Title : 未命名 -1 Creator Tool : CorelDRAW X6 Metadata Date : 2018:12:28 14:09:04-08:00 Producer : Corel PDF Engine Version 220.127.116.113 Document ID : uuid:c082cbb4-cc13-408a-bd4b-2dab5b07addc Instance ID : uuid:761bd434-1307-47b0-b1d3-5c4b85e36612 Page Count : 4 Profile CMM Type : Linotronic Profile Version : 2.1.0 Profile Class : Display Device Profile Color Space Data : RGB Profile Connection Space : XYZ Profile Date Time : 1998:02:09 06:49:00 Profile File Signature : acsp Primary Platform : Microsoft Corporation CMM Flags : Not Embedded, Independent Device Manufacturer : Hewlett-Packard Device Model : sRGB Device Attributes : Reflective, Glossy, Positive, Color Rendering Intent : Perceptual Connection Space Illuminant : 0.9642 1 0.82491 Profile Creator : Hewlett-Packard Profile ID : 0 Profile Copyright : Copyright (c) 1998 Hewlett-Packard Company Profile Description : sRGB IEC61966-2.1 Media White Point : 0.95045 1 1.08905 Media Black Point : 0 0 0 Red Matrix Column : 0.43607 0.22249 0.01392 Green Matrix Column : 0.38515 0.71687 0.09708 Blue Matrix Column : 0.14307 0.06061 0.7141 Device Mfg Desc : IEC http://www.iec.ch Device Model Desc : IEC 61966-2.1 Default RGB colour space - sRGB Viewing Cond Desc : Reference Viewing Condition in IEC61966-2.1 Viewing Cond Illuminant : 19.6445 20.3718 16.8089 Viewing Cond Surround : 3.92889 4.07439 3.36179 Viewing Cond Illuminant Type : D50 Luminance : 76.03647 80 87.12462 Measurement Observer : CIE 1931 Measurement Backing : 0 0 0 Measurement Geometry : Unknown Measurement Flare : 0.999% Measurement Illuminant : D65 Technology : Cathode Ray Tube Display Red Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Green Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Blue Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract)