CDRZ25 Wireless Charger User Manual SHENZHEN TORRAS TECHNOLOGY CO.,LTD.

SHENZHEN TORRAS TECHNOLOGY CO.,LTD. Wireless Charger

FCC ID Filing: 2AN4YCDRZ25
Purchase on Amazon: Wireless Charger

Trouble Viewing? See the or view the HTML Version or PDF in frame
Page 1 of CDRZ25 Wireless Charger User Manual  SHENZHEN TORRAS TECHNOLOGY CO.,LTD.

感谢您购买及使用本产品!
产品概况
使用说明
为了给您带来更好的使用体验,阅读本说明书的同时也请参阅您的手机或电子产品
说明书。
充电感应距离:手机内部感应线圈与无线充电器内部感应线圈的距离为(4-6)mm,
使用时手机请避免带较厚的手机壳。
1. 接通电源后,指示灯圈长亮几秒后熄灭;
为满足中国电子电气产品有害物质限制相关的法律法规和其他要求,对本产品中有
害物质,按部件分类,声明如下。
3. 感应到金属异物时,指示灯圈会不停的闪烁,并开启充电保护功能。
手机内部磁感应线圈
使用说明书
2. 将手机放在感应区内进入充电状态,指示灯圈长亮约15秒后熄灭;
中国有害物质声明
有害物质
(4 - 6)mm
手机
金属件
注:被充电设备必须符合Qi标准才能使用。
无线充电器
产品参数
镉
(Cd)
六价硌
(Cr(Vl))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
塑胶件
产 品 名 称
无线充电器
产 品 型 号
CDRZ25
外 壳 材 质
铝合金
无线充电感应区
导线
硅胶
其他
本表格依据SJ/T 11364的规定编制。某些型号的产品可能不包含表中的部分部件。
尺
寸
直径≈99mm、高度≈7.6mm
输
入
5V
2A, 9V
注意事项
1. 请勿用力挤压或碰撞该产品。
1.8A
3. 请勿将产品靠近火源或投入火中、水中。
率
10W Max
4. 请勿在严重高温、潮湿或腐蚀性情况下使用无线充电器,避免损坏电路出现漏电现
象。
充电感应距离
(4~6)mm
5. 请勿与带磁条或者芯片的磁卡(身份证、银行卡等)放置太近,避免造成磁性失效。
重
O:表示该有害物质在该部件所有均质材料中的含量均在GB/T 26572规定的限量
要求以下。
X:表示该有害物质至少在该部件的某一均质材料中的含量超出GB/T 26572规定
2. 请勿自行拆装分解或改造。
Type-c
输 入 接 口
净
汞
(Hg)
印刷电路
板及组件
无线充电器内部磁感应线圈
功
铅
(Pb)
6. 请勿将金属或带金属的手机壳放在充电器上。
≈100g
适 用 机 型
兼容Qi标准的苹果、三星、LG、Moto等全系列支持无线充电机型
产 品 清 单
无线充电器×1、Type-c数据线×1、说明书×1
的限量要求。标记“X”的部件,皆因全球技术发展水平限制而无法实现有害物
质的替代。
*印刷电路板组件包括印刷板及其零部件,电容和连接器等。
在中华人民共和国境内销售的电子信息产品必须标识此标志。圆圈内的数字表示正常
使用状态下产品的环保使用期限。
7. 请保持植入医疗设备(心脏起搏器、植入性耳蜗等)与无线充电器之间的距离至少为
20cm,以避免对医疗设备造成潜在干扰。
Type-c 输入口
8. 请保持充电器远离水或其它液体。
指示灯圈
9. 如需清洁充电器,请确保电源断开。
10. 请勿给儿童当玩具使用。
使用产品前请仔细阅读本使用说明书,并请妥善保管。
11. 使用环境温度保持在0-45℃。
Thank you for purchasing and using this product!
In order to bring you a better experience, read this manual and also please refer to your
mobile phone or electronic product manual.
Internal magnetic induction coil of cellphone
Phone
(4 - 6)mm
Wireless charger
USER'S GUIDE
Product Specifications:
Product Name
Wireless Charger
Sensor zone
CDRZ25
Shell material
Aluminum alloy
Size
Diameter≈99mm、Height≈7.6mm
Input
5V
Input interface
Type-c
Power
10W Max
Charging distance
(4~6)mm
Net weight
≈ 100g
Applicable models
The Qi standard of iPhone, Samsung, LG, Moto and other
whole series will support the wireless charging models.
2A, 9V
1.8A
Type-c input port
Indicator light
Instructions
The parameters above are derived from the laboratory of RANVOO, The actual parameter would
be different because of products or other factors.The image shown here is indicative only.
1. After the power source is switched on, the indicator light will be out after a few seconds.
2. Put the phone into the sensor zone and enter the charging status. The indicator light
will be extinguished after about 15 seconds.
3. When sensing a metal foreign object, the indicator will blink continuously and turn on
the charging protection function.
Product overview
Note: the charging equipment must meet the Qi standard to be used.
Product list
Please read this Operation Instruction carefully and keep it properly before using this product.
Internal magnetic induction
coil of Wireless charger
Model
Wireless charger ×1, Type-c cable ×1, Instruction book ×1
Charging induction distance: the distance between the inner induction coil of the
handset and the inner inductance coil of the wireless charger is (4-6) mm, and the
mobile phone avoids using a thicker mobile phone shell when using.
保修卡 Warranty Card
Notes
1. Do not press hard or crash the product.
2. Do not disassemble or reassemble.
3. Do not put the product near the fire or into the fire, water.
4. Do not use wireless charger in severe high temperature and humidity or corrosion to
avoid leakage.
5. Do not place too close to a magnetic card(id and bank card)with a magnetic strip or
chip to avoid the failure of the magnetism.
6. Do not put the iron or iron shell on the charger.
7. Please keep the distance between the implanted medical device (pacemakers,
implants, etc.) and the wireless charger at least 20cm to avoid potential interference
to the medical device.
8. Please keep the charger away from water or other liquids.
9. If you need to clean the charger,make sure it do not connect to the power.
10. Please do not use the toys for children.
11. The ambient temperature shall be kept between 0-45℃.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions (1)this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
联系电话 Customer Name:
购买日期 Phone Number:
客户姓名 Product Name:
产品名称 Date of Purchase:
地
备
址 Address:
注 Notes:
深圳市锐舞数码科技有限公司
SHENZHEN RANVOO DIGITAL TECHNOLOGY CO., LTD.
地址 : 深圳市龙华区民治大道展滔科技大厦 C 座 16 楼
ADD : 16 FLOOR, BLOCK C, ZHANTAO TECHNOLOGY BUILDING, MINZHI ROAD,LONGHUA
DISTRICT, SHENZHEN
国内热线 Domestic Tel: 400-838-2815
邮箱 Email: [email protected]
网址 Web: www.ranvoo.com
深圳市锐舞数码科技有限公司版权所有并保留一切权利
©Shenzhen RANVOO Digital Technology Co., Ltd. All Rights Reserved.
生产商:深圳正海欣科技有限公司
SHENZHEN ZHENGHAIXIN TECHNOLOGY CO., LTD.
生产商地址:广东省深圳市燕罗街道塘下涌社区雄宇路 7 号 301A 区
ADD : F/2,A AREA,301 ROOM,NO.7 ,XIONGYU ROAD,TANGXIAYONG COMMUNITY,YANLUO
STREET,BAOAN DISTRICT,SHENZHEN CITY,CHINA
执行标准 : GB 4943.1-2011
中国制造 Made in China
Download: CDRZ25 Wireless Charger User Manual  SHENZHEN TORRAS TECHNOLOGY CO.,LTD.
Mirror Download [FCC.gov]CDRZ25 Wireless Charger User Manual  SHENZHEN TORRAS TECHNOLOGY CO.,LTD.
Document ID3706290
Application IDZIHxOw5vAu0EWnriT0Hnjw==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize23.81kB (297678 bits)
Date Submitted2018-01-09 00:00:00
Date Available2018-01-09 00:00:00
Creation Date2018-01-02 16:57:37
Producing Software3-Heights(TM) PDF Optimization Shell 4.8.25.2 (http://www.pdf-tools.com)
Document Lastmod2018-01-02 09:15:43
Document TitleUser Manual
Document CreatorAdobe Illustrator CC 22.0 (Windows)

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Create Date                     : 2018:01:02 16:57:37+09:00
Creator                         : Adobe Illustrator CC 22.0 (Windows)
Title                           : 锐舞 -C8无线充电器 说明书
Modify Date                     : 2018:01:02 09:15:43Z
Producer                        : 3-Heights(TM) PDF Optimization Shell 4.8.25.2 (http://www.pdf-tools.com)
Page Count                      : 1
EXIF Metadata provided by EXIF.tools

Facebook Twitter Google+ RSS © FCCID.io 2018