1. FCC ID
  2. JUP
  3. JUP-48480-SNB900

FCC ID JUP-48480-SNB900

Trimble® SNB900 Radio Modem

by Trimble, Inc.

Grantee Code: JUP   Product Code: 48480SNB900
Latest application date: 2004-10-14

FCC ID Device Details

FCC IDJUP-48480-SNB900
Mirrorsfcc.id | gov | fccid.ai
Grantee CodeJUP
Product Code48480SNB900
Applicant BusinessTrimble, Inc. 🇺🇸
Related Domains trimble.com
Equipment ClassTrimble® SNB900 Radio Modem
Test FirmNational Technical Systems

Operating Frequencies

Frequency RangeApplication PurposeFinal Action Date
902.6-927.6 MHzOriginal Equipment2004-10-14

Exhibits

DocumentTypeAvailableFile
Manual revisedUsers Manual2004-10-14PDF 667.8 KB
Internal photosInternal Photos2004-10-14PDF 1.3 MB
External photosExternal Photos2004-10-14PDF 495.3 KB
FCC ID labelID Label/Location Info2004-10-14PDF 192.4 KB
FCC ID label locationID Label/Location Info2004-10-14PDF 63.6 KB
Set up photosTest Setup Photos2004-10-14PDF 346.9 KB
Test report revisedTest Report2004-10-14PDF 562.1 KB
ATCB commentsCover Letter(s)2004-10-14PDF 46.6 KB
POACover Letter(s)2004-10-14PDF 90.1 KB
Request for confidentialityCover Letter(s)2004-10-14PDF 90 KB
Response to ATCBCover Letter(s)2004-10-14PDF 28.8 KB
MPERF Exposure Info2004-10-14PDF 33.1 KB

Application Information

Application ID+5I+Ys8ApEVhShieobwisA==
Final Action Date2004-10-14
Application PurposeOriginal Equipment
Applicant FRN0005921291
Model48480-SNB900
Frequency Range902.6-927.6 MHz
Equipment ClassDSS - Part 15 Spread Spectrum Transmitter
Device DescriptionTrimble® SNB900 Radio Modem
Responsible PartyTony Phan, GNSS Regulatory Compliance Manager, tony_phan@trimble.com , 4084818491
AgentMark Mark Mark, Elliott Laboratories, Inc., doc@elliottlabs.com , 408-245-7800
Technical ContactMark Briggs, Elliott Laboratories, Inc., doc@elliottlabs.com , 408-245-7800
Test FirmDavid Bare, National Technical Systems, david.bare@nts.com , 510-578-3500
TCB Emailhotline@americantcb.com
TCB ScopeA4: UNII devices & low power transmitters using spread spectrum techniques
Short-Term ConfidentialityNo
Long-Term ConfidentialityYes
Grant DeferralNo
Modular EquipmentDoes not apply
Composite DeviceNo
Composite PartNo
Cognitive RadioNo
Authorization WaiverNo
Authorization Waiver ApprovedNo
Section 5301 CertificationYes
Related OET Knowledge DataBase InquiryNo
Grant CommentsPower Output listed is Conducted. The antenna used with this transmitter must be installed to provide a separation distance of at least 21 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

Applications

Application IDDatePurpose
+5I+Ys8ApEVhShieobwisA==2004-10-14Original Equipment

Equipment Authorization

FrequencyOutputRulesGrant Notes
902.6-927.6 MHz0.832000015C20

Grants

TCB Grant - Application +5I+Ys8ApEVhShieobwisA==

TCB GRANT OF EQUIPMENT
AUTHORIZATION		 TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  ACB, Inc.
6731 Whittier Avenue Suite C110
McLean, VA 22101
 Date of Grant: 10/14/2004

Application Dated: 10/14/2004
Trimble, Inc.
935 Stewart Drive
Sunnyvale, CA 94085
 
Attention: Tony Phan , GNSS Regulatory Compliance Manager

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  JUP-48480-SNB900
Name of Grantee:  Trimble, Inc.
Equipment Class: Part 15 Spread Spectrum Transmitter
Notes: Trimble® SNB900 Radio Modem
Grant Notes  FCC Rule Parts Frequency
Range (MHZ) 		Output
Watts 		Frequency
Tolerance 		Emission
Designator
20 15C 902.6  -  927.6 0.832  

Power Output listed is Conducted. The antenna used with this transmitter must be installed to provide a separation distance of at least 21 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.

EAS Grant - Application +5I+Ys8ApEVhShieobwisA==

COPY FEDERAL COMMUNICATIONS
COMMISSION
WASHINGTON, D.C. 20554

GRANT OF EQUIPMENT
AUTHORIZATION		 COPY
Certification

Trimble, Inc.
935 Stewart Drive
Sunnyvale, CA 94085
United States 		  Date of Grant: 10/14/2004

Application Dated: 10/14/2004
 
Attention: Tony Phan , GNSS Regulatory Compliance Manager

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  JUP-48480-SNB900
Name of Grantee:  Trimble, Inc.
Equipment Class: Part 15 Spread Spectrum Transmitter
Notes: Trimble® SNB900 Radio Modem
Modular Type: Does not apply
Grant Notes  FCC Rule Parts Frequency
Range (MHZ) 		Output
Watts 		Frequency
Tolerance 		Emission
Designator
20 15C 902.6  -  927.6 0.832  

Power Output listed is Conducted. The antenna used with this transmitter must be installed to provide a separation distance of at least 21 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.


20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.

Mail To: