FCC ID KA2IR503A
DLINK N-150 Wireless Mini Router DIR-503A
by D-Link Corporation
Grantee Code: KA2 Product Code: IR503A
Latest application date: 2013-08-29
FCC ID Device Details
Operating Frequencies
| Frequency Range | Application Purpose | Final Action Date |
|---|---|---|
| 2412-2462 MHz | Original Equipment | 2013-08-29 |
Exhibits
| Document | Type | Available | File |
|---|---|---|---|
| Addendum | Users Manual | 2013-08-29 | PDF 30.6 KB |
| Manual | Users Manual | 2013-08-29 | PDF 2 MB |
| Ops | Operational Description | 2013-08-29 | PDF 37.2 KB |
| Int | Internal Photos | 2013-08-29 | PDF 684.4 KB |
| Ext | External Photos | 2013-08-29 | PDF 280.4 KB |
| Label | ID Label/Location Info | 2013-08-29 | PDF 686.3 KB |
| Location | ID Label/Location Info | 2013-08-29 | PDF 125.1 KB |
| Block | Block Diagram | 2013-08-29 | PDF 19.2 KB |
| Schema | Schematics | 2013-08-29 | PDF 205.9 KB |
| Ant Spec | Operational Description | 2013-08-29 | PDF 1,022.6 KB |
| Setup | Test Setup Photos | 2013-08-29 | PDF 246.3 KB |
| Test Report | Test Report | 2013-08-29 | PDF 1.1 MB |
| Authorization | Cover Letter(s) | 2013-08-29 | PDF 19.8 KB |
| Confid | Cover Letter(s) | 2013-08-29 | PDF 78.1 KB |
| DofC | Cover Letter(s) | 2013-08-29 | PDF 81 KB |
| RFx r1 | RF Exposure Info | 2013-08-29 | PDF 39.3 KB |
Application Information
| Application ID | adoUmHvnIDEGvX8hvWiIpA== |
|---|---|
| Final Action Date | 2013-08-29 |
| Application Purpose | Original Equipment |
| Applicant FRN | 0006207146 |
| Model | IR503A |
| Frequency Range | 2412-2462 MHz |
| Equipment Class | DTS - Digital Transmission System |
| Device Description | DLINK N-150 Wireless Mini Router DIR-503A |
| Responsible Party | Michael Boschma, Engineer, MBoschma@dlink.com  , 714-885-6105 |
| Technical Contact | Mark Koop, Teleconformity, mark.koop@teleconformity.com  , (31)848395876 |
| Test Firm | Miro Chueh, Cerpass Technology (SuZhou) Co., Ltd., miroc@cerpass.net  , 86-0512-69175888 |
| TCB Email | certification@micomlabs.com  |
| TCB Scope | A4: UNII devices & low power transmitters using spread spectrum techniques |
| Short-Term Confidentiality | No |
| Long-Term Confidentiality | Yes |
| Grant Deferral | No |
| Modular Equipment | Does not apply |
| Composite Device | No |
| Composite Part | No |
| Cognitive Radio | No |
| Authorization Waiver | No |
| Authorization Waiver Approved | No |
| Section 5301 Certification | Yes |
| Related OET Knowledge DataBase Inquiry | No |
| Grant Comments | Power Output listed is Conducted. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. |
Applications
| Application ID | Date | Purpose |
|---|---|---|
| adoUmHvnIDEGvX8hvWiIpA== | 2013-08-29 | Original Equipment |
Equipment Authorization
Grants
TCB Grant - Application adoUmHvnIDEGvX8hvWiIpA==
| TCB | GRANT OF EQUIPMENT AUTHORIZATION |
TCB |
| Certification | ||
| Issued Under the Authority of the | ||
| Federal Communications Commission | ||
| By: |
|
MiCOM Labs 575 Boulder Court Pleasanton, CA 94566 |
Date of Grant: 08/29/2013 Application Dated: 08/29/2013 |
| D Link Corporation |
| 17595 Mt. Herrmann |
| Fountain Valley, CA 92708 |
| Attention: Michael Boschma , Engineer |
| NOT TRANSFERABLE |
| EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below. |
| FCC IDENTIFIER: | KA2IR503A |
| Name of Grantee: | D Link Corporation |
| Equipment Class: | Digital Transmission System |
| Notes: | DLINK N-150 Wireless Mini Router DIR-503A |
| Grant Notes | FCC Rule Parts | Frequency Range (MHZ) | Output Watts | Frequency Tolerance | Emission Designator |
| 20 | 15C | 2412.0 - 2462.0 | 0.0574 | ||
| 20 | 15C | 2422.0 - 2452.0 | 0.0298 |
| Power Output listed is Conducted. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. |
| 20: | All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed. |
EAS Grant - Application adoUmHvnIDEGvX8hvWiIpA==
| COPY |
FEDERAL COMMUNICATIONS COMMISSION WASHINGTON, D.C. 20554 GRANT OF EQUIPMENT AUTHORIZATION |
COPY |
| Certification |
|
D Link Corporation 17595 Mt. Herrmann Fountain Valley, CA 92708 United States |
Date of Grant: 08/29/2013 Application Dated: 08/29/2013 |
| Attention: Michael Boschma , Engineer |
| NOT TRANSFERABLE |
| EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below. |
| FCC IDENTIFIER: | KA2IR503A |
| Name of Grantee: | D Link Corporation |
| Equipment Class: | Digital Transmission System |
| Notes: | DLINK N-150 Wireless Mini Router DIR-503A |
| Modular Type: | Does not apply |
| Grant Notes | FCC Rule Parts | Frequency Range (MHZ) | Output Watts | Frequency Tolerance | Emission Designator |
| 20 | 15C | 2412.0 - 2462.0 | 0.0574 | ||
| 20 | 15C | 2422.0 - 2452.0 | 0.0298 |
| Power Output listed is Conducted. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. |
| 20: | All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed. |
| Mail To: |