FCC ID OWS-NIC441
NIC Module for Network Relay Points
by Itron, Inc
Grantee Code: OWS Product Code: NIC441
Latest application date: 2014-04-03
FCC ID Device Details
Operating Frequencies
| Frequency Range | Application Purpose | Final Action Date |
|---|---|---|
| 902.2-927.8 MHz | Original Equipment | 2014-04-03 |
Exhibits
| Document | Type | Available | File |
|---|---|---|---|
| Labeling Requirements | Users Manual | 2014-09-25 | PDF 529.6 KB |
| Internal Photo NDA | Cover Letter(s) | 2014-04-03 | PDF 171.2 KB |
| Ext | External Photos | 2014-09-25 | PDF 1.2 MB |
| Label | ID Label/Location Info | 2014-04-03 | PDF 187 KB |
| Setup | Test Setup Photos | 2014-09-25 | PDF 5.5 MB |
| DSS DTS Report | Test Report | 2014-04-03 | PDF 2.8 MB |
| Authorization | Cover Letter(s) | 2014-04-03 | PDF 209.2 KB |
| LTC | Cover Letter(s) | 2014-04-03 | PDF 185.1 KB |
| Modular Request | Cover Letter(s) | 2014-04-03 | PDF 195 KB |
| STC | Cover Letter(s) | 2014-04-03 | PDF 184.1 KB |
| RFx | RF Exposure Info | 2014-04-03 | PDF 98.1 KB |
| Int Metadata only | Internal Photos | PDF 828.3 KB | |
| Block Metadata only | Block Diagram | PDF 148.2 KB | |
| Schema Metadata only | Schematics | PDF 224.4 KB | |
| Ops Metadata only | Operational Description | PDF 283.8 KB |
Application Information
| Application ID | r1NStew4pOvldHfMZ/onCQ== |
|---|---|
| Final Action Date | 2014-04-03 |
| Application Purpose | Original Equipment |
| Applicant FRN | 0017775842 |
| Model | NIC441 |
| Frequency Range | 902.2-927.8 MHz |
| Equipment Class | DSS - Part 15 Spread Spectrum Transmitter |
| Device Description | NIC Module for Network Relay Points |
| Responsible Party | Asim Tirmizi, Regulatory Engineering Manager, Asim.Tirmizi@itron.com  , 669-770-4000 |
| Test Firm | Gordon Hurst, MiCOM Labs, gordon_hurst@micomlabs.com  , 925-462-0304 |
| TCB Email | certification@micomlabs.com |
| TCB Scope | A4: UNII devices & low power transmitters using spread spectrum techniques |
| Short-Term Confidentiality | Yes |
| Short-Term Confidentiality Date | 09/25/2014 |
| Long-Term Confidentiality | Yes |
| Grant Deferral | No |
| Modular Equipment | Single Modular Approval |
| Composite Device | No |
| Composite Part | No |
| Cognitive Radio | No |
| Authorization Waiver | No |
| Authorization Waiver Approved | No |
| Section 5301 Certification | Yes |
| Related OET Knowledge DataBase Inquiry | No |
| Grant Comments | Power Output listed is Conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. |
Applications
| Application ID | Date | Purpose |
|---|---|---|
| r1NStew4pOvldHfMZ/onCQ== | 2014-04-03 | Original Equipment |
Equipment Authorization
Grants
TCB Grant - Application r1NStew4pOvldHfMZ/onCQ==
| TCB | GRANT OF EQUIPMENT AUTHORIZATION |
TCB |
| Certification | ||
| Issued Under the Authority of the | ||
| Federal Communications Commission | ||
| By: |
|
MiCOM Labs 575 Boulder Court Pleasanton, CA 94566 |
Date of Grant: 04/03/2014 Application Dated: 04/03/2014 |
| Itron, Inc |
| 230 W. Tasman Dr. |
| San Jose, CA 95134 |
| Attention: Asim Tirmizi , Regulatory Engineering Manager |
| NOT TRANSFERABLE |
| EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below. |
| FCC IDENTIFIER: | OWS-NIC441 |
| Name of Grantee: | Itron, Inc |
| Equipment Class: | Part 15 Spread Spectrum Transmitter |
| Notes: | NIC Module for Network Relay Points |
| Modular Type: | Single Modular |
| Grant Notes | FCC Rule Parts | Frequency Range (MHZ) | Output Watts | Frequency Tolerance | Emission Designator |
| 20 | 15C | 902.2 - 927.8 | 0.96 | ||
| 20 | 15C | 2400.8 - 2472.8 | 0.28 | ||
| 20 | 15C | 2405.0 - 2480.0 | 0.18 |
| Power Output listed is Conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. |
| 20: | All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed. |
EAS Grant - Application r1NStew4pOvldHfMZ/onCQ==
| COPY |
FEDERAL COMMUNICATIONS COMMISSION WASHINGTON, D.C. 20554 GRANT OF EQUIPMENT AUTHORIZATION |
COPY |
| Certification |
|
Itron, Inc 230 W. Tasman Dr. San Jose, CA 95134 United States |
Date of Grant: 04/03/2014 Application Dated: 04/03/2014 |
| Attention: Asim Tirmizi , Regulatory Engineering Manager |
| NOT TRANSFERABLE |
| EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below. |
| FCC IDENTIFIER: | OWS-NIC441 |
| Name of Grantee: | Itron, Inc |
| Equipment Class: | Part 15 Spread Spectrum Transmitter |
| Notes: | NIC Module for Network Relay Points |
| Modular Type: | Single Modular |
| Grant Notes | FCC Rule Parts | Frequency Range (MHZ) | Output Watts | Frequency Tolerance | Emission Designator |
| 20 | 15C | 902.2 - 927.8 | 0.96 | ||
| 20 | 15C | 2400.8 - 2472.8 | 0.28 | ||
| 20 | 15C | 2405.0 - 2480.0 | 0.18 |
| Power Output listed is Conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. |
| 20: | All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed. |
| Mail To: |