FCC ID P76MWBPA-D10

Bluetooth Protocol Analyzer

by Mobiwave Pte. Ltd.

Grantee Code: P76   Product Code: MWBPAD10
Latest application date: 2002-04-16

FCC ID Device Details

FCC IDP76MWBPA-D10
Mirrorsfcc.id | gov | fccid.ai
Grantee CodeP76
Product CodeMWBPAD10
Applicant BusinessMobiwave Pte. Ltd. 🇸🇬
Related Domains psbcorp.com
Equipment ClassBluetooth Protocol Analyzer
Test FirmTUV SUD PSB Pte Ltd

Operating Frequencies

Frequency RangeApplication PurposeFinal Action Date
2402-2480 MHzOriginal Equipment2002-04-16

Exhibits

DocumentTypeAvailableFile
revised users manualUsers Manual2002-04-16PDF 1.8 MB
internal photosInternal Photos2002-04-16PDF 956.8 KB
external photosExternal Photos2002-04-16PDF 380.1 KB
label and locationID Label/Location Info2002-04-16PDF 122.3 KB
block diagramBlock Diagram2002-04-16PDF 7.2 KB
descriptionOperational Description2002-04-16PDF 14.5 KB
setup photosTest Setup Photos2002-04-16PDF 446.4 KB
Antenna DeclarationTest Report2002-04-16PDF 47.2 KB
request for technical infoTest Report2002-04-16PDF 6.1 KB
test report revisedTest Report2002-04-16PDF 700 KB
Letter of AuthorizationCover Letter(s)2002-04-16PDF 32.8 KB
confidentiality requestCover Letter(s)2002-04-16PDF 98.9 KB
baseband schematic Metadata onlySchematicsPDF 174.9 KB
controller schematic Metadata onlySchematicsPDF 271.3 KB

Application Information

Application IDulVLtn707884HjD7rv47mg==
Final Action Date2002-04-16
Application PurposeOriginal Equipment
Applicant FRN0006575146
ModelMWBPA-D10
Frequency Range2402-2480 MHz
Equipment ClassDSS - Part 15 Spread Spectrum Transmitter
Device DescriptionBluetooth Protocol Analyzer
Responsible PartyChia Hang Poh, Director, Engineering, natarajan-s.suresh@psbcorp.com , 65-6297-7706
AgentChris Chris Chris, MET Laboratories, Inc., charvey@metlabs.com , 410-354-3300
Test FirmHarold Tan, TUV SUD PSB Pte Ltd, harold.tan@tuv-sud-psb.sg , 65-6885-1504
TCB Emailcharvey@metlabs.com
TCB ScopeA4: UNII devices & low power transmitters using spread spectrum techniques
Short-Term ConfidentialityNo
Long-Term ConfidentialityYes
Grant DeferralNo
Modular EquipmentDoes not apply
Composite DeviceNo
Composite PartNo
Cognitive RadioNo
Authorization WaiverNo
Authorization Waiver ApprovedNo
Section 5301 CertificationYes
Related OET Knowledge DataBase InquiryNo
Grant CommentsThe antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. This device complies with the provisions of FCC 15.249 in the single-frequency mode. This device has been approved for use with the antennas specified in the filing.

Applications

Application IDDatePurpose
ulVLtn707884HjD7rv47mg==2002-04-16Original Equipment

Equipment Authorization

FrequencyOutputRulesGrant Notes
2402-2480 MHz0.060000015C20

Grants

TCB Grant - Application ulVLtn707884HjD7rv47mg==

TCB GRANT OF EQUIPMENT
AUTHORIZATION
TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  Eurofins Electrical and Electronic Testing NA, Inc
914 W. Patapsco Avenue
Baltimore, MD 21230-3432
Date of Grant: 04/16/2002

Application Dated: 04/16/2002
Mobiwave Pte. Ltd.
Blk 65A, Jalan Tenteram, #04-03
Singapore, 328958
Singapore
 
Attention: Chia Hang Poh , Director, Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  P76MWBPA-D10
Name of Grantee:  Mobiwave Pte. Ltd.
Equipment Class: Part 15 Spread Spectrum Transmitter
Notes: Bluetooth Protocol Analyzer
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
20 15C 2402.0  -  2480.0 0.06  

The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. This device complies with the provisions of FCC 15.249 in the single-frequency mode. This device has been approved for use with the antennas specified in the filing.

20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.

EAS Grant - Application ulVLtn707884HjD7rv47mg==

COPY FEDERAL COMMUNICATIONS
COMMISSION
WASHINGTON, D.C. 20554

GRANT OF EQUIPMENT
AUTHORIZATION
COPY
Certification

Mobiwave Pte. Ltd.
Blk 65A, Jalan Tenteram, #04-03
Singapore, 328958
Singapore
  Date of Grant: 04/16/2002

Application Dated: 04/16/2002
 
Attention: Chia Hang Poh , Director, Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  P76MWBPA-D10
Name of Grantee:  Mobiwave Pte. Ltd.
Equipment Class: Part 15 Spread Spectrum Transmitter
Notes: Bluetooth Protocol Analyzer
Modular Type: Does not apply
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
20 15C 2402.0  -  2480.0 0.06  

The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. This device complies with the provisions of FCC 15.249 in the single-frequency mode. This device has been approved for use with the antennas specified in the filing.


20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.

Mail To: