FCC ID Q7V-3F090003X

Wi.232 Transmitter

by Linx Technologies

Grantee Code: Q7V   Product Code: 3F090003X
Latest application date: 2005-12-13

FCC ID Device Details

FCC IDQ7V-3F090003X
Mirrorsfcc.id | gov | fccid.ai
Grantee CodeQ7V
Product Code3F090003X
Applicant BusinessLinx Technologies 🇺🇸
Related Domains linxtechnologies.com radiotronix.com
Equipment ClassWi.232 Transmitter
Test FirmNebraska Center for Excellence in Electronics

Operating Frequencies

Frequency RangeApplication PurposeFinal Action Date
905.572-927.228 MHzOriginal Equipment2005-12-13
902.971-926.277 MHzOriginal Equipment2005-12-13

Exhibits

DocumentTypeAvailableFile
Users Manual Revision 4Users Manual2005-12-13PDF 435.9 KB
Additional Internal PhotosInternal Photos2005-12-13PDF 191.3 KB
Internal PhotosInternal Photos2005-12-13PDF 320.1 KB
Additional External PhotosExternal Photos2005-12-13PDF 191.3 KB
External PhotosExternal Photos2005-12-13PDF 320.1 KB
Label LocationID Label/Location Info2005-12-13PDF 78.8 KB
Sample LabelID Label/Location Info2005-12-13PDF 6.4 KB
Test PhotosTest Setup Photos2005-12-13PDF 203.4 KB
Test Report Revision DTest Report2005-12-13PDF 1.1 MB
Firmware Change AttestationAttestation Statements2005-12-13PDF 263.4 KB
Firmware Changes AttestationAttestation Statements2005-12-13PDF 263.4 KB
Agency LetterCover Letter(s)2005-12-13PDF 563.9 KB
Comments 4Cover Letter(s)2005-12-13PDF 58.4 KB
Comments and Response 5Cover Letter(s)2005-12-13PDF 94.5 KB
Confidentiality LetterCover Letter(s)2005-12-13PDF 562.5 KB
Modular Request LetterCover Letter(s)2005-12-13PDF 93.9 KB
Modular Request LetterCover Letter(s)2005-12-13PDF 93.9 KB
RF Exposure InfoRF Exposure Info2005-12-13PDF 7.6 KB
Block Diagram Metadata onlyBlock DiagramPDF 22.1 KB
Block Diagram 1 Metadata onlyBlock DiagramPDF 22.1 KB
Block Diagram 2 Metadata onlyBlock DiagramPDF 39.9 KB
Schematics 1 Metadata onlySchematicsPDF 20.9 KB
Schematics 2 Metadata onlySchematicsPDF 16.6 KB
Antenna 1 Information Metadata onlyOperational DescriptionPDF 39.4 KB
Antenna 1 information Metadata onlyOperational DescriptionPDF 39.4 KB
Antenna 2 Information Metadata onlyOperational DescriptionPDF 39.3 KB
Antenna 2 information Metadata onlyOperational DescriptionPDF 39.3 KB
Antenna 3 Information Metadata onlyOperational DescriptionPDF 40.9 KB
Frequencies of Operation Revised Metadata onlyOperational DescriptionPDF 25.7 KB
Operational Description Revision 112105 Metadata onlyOperational DescriptionPDF 616.9 KB

Application Information

Application IDsubABVg5ZHp7eSqAfVW3gw==
Final Action Date2005-12-13
Application PurposeOriginal Equipment
Applicant FRN0009060302
Model3F090003X
Frequency Range905.572-927.228 MHz
Equipment ClassDXT - Part 15 Low Power Transceiver, Rx Verified
Device DescriptionWi.232 Transmitter
Responsible PartyShawn Hogan, Director of Engineering, shwnho@linxtechnologies.com , 541-472-3709
AgentDoug Doug Doug, NCEE Labs, dkramer@nceelabs.com , 402-472-5880
Technical ContactTom Marks, Radiotronix Inc., tmarks@radiotronix.com , 405-794-7730
Non-Technical ContactKregg Kepler, Radiotronix, Inc., kreggk@radiotronix.com , 405-794-7730
Test FirmNic Johnson, Nebraska Center for Excellence in Electronics, njohnson@nceelabs.com , 4023236233
TCB Emailhotline@AmericanTCB.com
TCB ScopeA1: Low Power Transmitters below 1 GHz (except Spread Spectrum), Unintentional Radiators, EAS (Part 11) & Consumer ISM devices
Short-Term ConfidentialityNo
Long-Term ConfidentialityYes
Grant DeferralNo
Modular EquipmentLimited Single Modular Approval
Composite DeviceYes
Composite PartNo
Cognitive RadioNo
Authorization WaiverNo
Authorization Waiver ApprovedNo
Section 5301 CertificationYes
Related OET Knowledge DataBase InquiryNo
Grant CommentsLimited Modular Approval (LMA). Certain antennas are approved only for specific modes of operation as given in this application. To meet requirements of 15.15, end users must not be able to change mode of operation of this device. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end user has no manual instructions to remove or install the device. For operation under 15.247, the antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

Applications

Application IDDatePurpose
subABVg5ZHp7eSqAfVW3gw==2005-12-13Original Equipment
8PU+1r2FGAcuW5H6efHr9w==2005-12-13Original Equipment

Equipment Authorization

FrequencyOutputRulesGrant Notes
902.971-926.277 MHz0.024000015C20, CC
905.572-927.228 MHz15C20, CC

Grants

TCB Grant - Application subABVg5ZHp7eSqAfVW3gw==

TCB GRANT OF EQUIPMENT
AUTHORIZATION
TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  ACB, Inc.
6731 Whittier Avenue Suite C110
McLean, VA 22101
Date of Grant: 12/13/2005

Application Dated: 12/13/2005
Linx Technologies
159 Ort Lane
Merlin, OR 97532
 
Attention: Shawn Hogan , Director of Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  Q7V-3F090003X
Name of Grantee:  Linx Technologies
Equipment Class: Part 15 Low Power Transceiver, Rx Verified
Notes: Wi.232 Transmitter
Modular Type: Limited Single Modular
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
20 CC 15C 905.572  -  927.228  

Limited Modular Approval (LMA). Certain antennas are approved only for specific modes of operation as given in this application. To meet requirements of 15.15, end users must not be able to change mode of operation of this device. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end user has no manual instructions to remove or install the device. For operation under 15.247, the antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.
CC: This device is certified pursuant to two different Part 15 rules sections.

EAS Grant - Application subABVg5ZHp7eSqAfVW3gw==

COPY FEDERAL COMMUNICATIONS
COMMISSION
WASHINGTON, D.C. 20554

GRANT OF EQUIPMENT
AUTHORIZATION
COPY
Certification

Linx Technologies
159 Ort Lane
Merlin, OR 97532
United States
  Date of Grant: 12/13/2005

Application Dated: 12/13/2005
 
Attention: Shawn Hogan , Director of Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  Q7V-3F090003X
Name of Grantee:  Linx Technologies
Equipment Class: Part 15 Low Power Transceiver, Rx Verified
Notes: Wi.232 Transmitter
Modular Type: Limited Single Modular
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
20 CC 15C 905.572  -  927.228  

Limited Modular Approval (LMA). Certain antennas are approved only for specific modes of operation as given in this application. To meet requirements of 15.15, end users must not be able to change mode of operation of this device. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end user has no manual instructions to remove or install the device. For operation under 15.247, the antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.


20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.
CC: This device is certified pursuant to two different Part 15 rules sections.

TCB Grant - Application 8PU+1r2FGAcuW5H6efHr9w==

Mail To:
TCB GRANT OF EQUIPMENT
AUTHORIZATION
TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  ACB, Inc.
6731 Whittier Avenue Suite C110
McLean, VA 22101
Date of Grant: 12/13/2005

Application Dated: 12/13/2005
Linx Technologies
159 Ort Lane
Merlin, OR 97532
 
Attention: Shawn Hogan , Director of Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  Q7V-3F090003X
Name of Grantee:  Linx Technologies
Equipment Class: Digital Transmission System
Notes: Wi.232 Transmitter
Modular Type: Limited Single Modular
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
20 CC 15C 902.971  -  926.277 0.024  

Power Output listed is Conducted. Limited Modular Approval (LMA). Certain antennas are approved only for specific modes of operation as given in this application. To meet requirements of 15.15, end users must not be able to change mode of operation of this device. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end user has no manual instructions to remove or install the device. For operation under 15.247, the antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.
CC: This device is certified pursuant to two different Part 15 rules sections.

EAS Grant - Application 8PU+1r2FGAcuW5H6efHr9w==

COPY FEDERAL COMMUNICATIONS
COMMISSION
WASHINGTON, D.C. 20554

GRANT OF EQUIPMENT
AUTHORIZATION
COPY
Certification

Linx Technologies
159 Ort Lane
Merlin, OR 97532
United States
  Date of Grant: 12/13/2005

Application Dated: 12/13/2005
 
Attention: Shawn Hogan , Director of Engineering

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  Q7V-3F090003X
Name of Grantee:  Linx Technologies
Equipment Class: Digital Transmission System
Notes: Wi.232 Transmitter
Modular Type: Limited Single Modular
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
20 CC 15C 902.971  -  926.277 0.024  

Power Output listed is Conducted. Limited Modular Approval (LMA). Certain antennas are approved only for specific modes of operation as given in this application. To meet requirements of 15.15, end users must not be able to change mode of operation of this device. This grant is valid only when the device is sold to OEM integrators and the OEM integrators are instructed to ensure that the end user has no manual instructions to remove or install the device. For operation under 15.247, the antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.


20: All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed.
CC: This device is certified pursuant to two different Part 15 rules sections.

Mail To: