FCC ID TS4-TW223

RPT TW223

by Tehama Wireless Design Group Inc.

Grantee Code: TS4   Product Code: TW223
Latest application date: 2019-06-30

FCC ID Device Details

FCC IDTS4-TW223
Mirrorsfcc.id | gov | fccid.ai
Grantee CodeTS4
Product CodeTW223
Applicant BusinessTehama Wireless Design Group Inc. 🇺🇸
Related Domains tehamawireless.com
Equipment ClassRPT TW223
Test FirmCompliance Testing, LLC

Operating Frequencies

Frequency RangeApplication PurposeFinal Action Date
906-924 MHzOriginal Equipment2019-06-30
906-924 MHzOriginal Equipment2019-06-30

Exhibits

DocumentTypeAvailableFile
UMUsers Manual2019-12-28PDF 348.2 KB
INT PHOInternal Photos2019-12-28PDF 655.5 KB
EXT PHOExternal Photos2019-12-28PDF 259.6 KB
labelID Label/Location Info2019-06-30PDF 521.3 KB
Test setup photoTest Setup Photos2019-12-28PDF 319.5 KB
ANNEX A-1Test Report2019-06-30PDF 169.1 KB
ANNEX A-2Test Report2019-06-30PDF 186.9 KB
ANNEX A-3Test Report2019-06-30PDF 258.3 KB
ANNEX B-1Test Report2019-06-30PDF 181.8 KB
ANNEX B-2Test Report2019-06-30PDF 182.2 KB
ANNEX B-3Test Report2019-06-30PDF 152 KB
ANNEX CTest Report2019-06-30PDF 189.7 KB
TEST REPORTTest Report2019-06-30PDF 549.9 KB
FCC Authorization letterCover Letter(s)2019-06-30PDF 142.6 KB
FCC Confidence letterCover Letter(s)2019-06-30PDF 305 KB
FCC confidence letterCover Letter(s)2019-06-30PDF 305 KB
RF exposure letterRF Exposure Info2019-06-30PDF 278.5 KB
block diagram Metadata onlyBlock DiagramPDF 98.4 KB
block diagram Metadata onlyBlock DiagramPDF 138.3 KB
SCH Metadata onlySchematicsPDF 631.5 KB
SCH Metadata onlySchematicsPDF 1.5 MB
OP Metadata onlyOperational DescriptionPDF 168 KB
BOM Metadata onlyParts List/Tune Up InfoPDF 426.8 KB
BOM Metadata onlyParts List/Tune Up InfoPDF 213.4 KB

Application Information

Application IDucY1brUHnAv+tlfc+HoBvg==
Final Action Date2019-06-30
Application PurposeOriginal Equipment
Applicant FRN0014107304
ModelTW223
Frequency Range906-924 MHz
Equipment ClassDSS - Part 15 Spread Spectrum Transmitter
Device DescriptionRPT TW223
Responsible PartyJames Orton, President, jorton@tehamawireless.com , 415-495-7344
Test FirmMichael Schafer, Compliance Testing, LLC, michaels@compliancetesting.com , 480-926-3100
TCB Emaildarial@compliancetesting.com
TCB ScopeA4: UNII devices & low power transmitters using spread spectrum techniques
Short-Term ConfidentialityYes
Short-Term Confidentiality Date12/28/2019
Long-Term ConfidentialityYes
Grant DeferralNo
Modular EquipmentDoes not apply
Composite DeviceYes
Composite PartNo
Cognitive RadioNo
Authorization WaiverNo
Authorization Waiver ApprovedNo
Section 5301 CertificationYes
Related OET Knowledge DataBase InquiryNo
Grant CommentsPower output listed is conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

Applications

Application IDDatePurpose
ucY1brUHnAv+tlfc+HoBvg==2019-06-30Original Equipment
lWmYBIyqkgbTwciWtlQm0A==2019-06-30Original Equipment

Equipment Authorization

FrequencyOutputRules
906-924 MHz0.061944015C
906-924 MHz0.105439015C

Grants

TCB Grant - Application ucY1brUHnAv+tlfc+HoBvg==

TCB GRANT OF EQUIPMENT
AUTHORIZATION
TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  Compliance Testing, LLC
1724 S. Nevada Way
Mesa, AZ 85204
Date of Grant: 06/30/2019

Application Dated: 06/18/2019
Tehama Wireless Design Group Inc.
2607 7th st
Suite G
Berkeley, CA 94710
 
Attention: James Orton , President

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  TS4-TW223
Name of Grantee:  Tehama Wireless Design Group Inc.
Equipment Class: Part 15 Spread Spectrum Transmitter
Notes: RPT TW223
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
15C 906.0  -  924.0 0.105439  

Power output listed is conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

EAS Grant - Application ucY1brUHnAv+tlfc+HoBvg==

COPY FEDERAL COMMUNICATIONS
COMMISSION
WASHINGTON, D.C. 20554

GRANT OF EQUIPMENT
AUTHORIZATION
COPY
Certification

Tehama Wireless Design Group Inc.
2607 7th st Suite G
Berkeley, CA 94710
United States
  Date of Grant: 06/30/2019

Application Dated: 06/18/2019
 
Attention: James Orton , President

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  TS4-TW223
Name of Grantee:  Tehama Wireless Design Group Inc.
Equipment Class: Part 15 Spread Spectrum Transmitter
Notes: RPT TW223
Modular Type: Does not apply
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
15C 906.0  -  924.0 0.105439  

Power output listed is conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.



TCB Grant - Application lWmYBIyqkgbTwciWtlQm0A==

Mail To:
TCB GRANT OF EQUIPMENT
AUTHORIZATION
TCB
Certification
Issued Under the Authority of the
Federal Communications Commission
By:

  Compliance Testing, LLC
1724 S. Nevada Way
Mesa, AZ 85204
Date of Grant: 06/30/2019

Application Dated: 06/30/2019
Tehama Wireless Design Group Inc.
2607 7th st
Suite G
Berkeley, CA 94710
 
Attention: James Orton , President

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  TS4-TW223
Name of Grantee:  Tehama Wireless Design Group Inc.
Equipment Class: Digital Transmission System
Notes: RPT TW223
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
15C 906.0  -  924.0 0.061944  

Power output listed is conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

EAS Grant - Application lWmYBIyqkgbTwciWtlQm0A==

COPY FEDERAL COMMUNICATIONS
COMMISSION
WASHINGTON, D.C. 20554

GRANT OF EQUIPMENT
AUTHORIZATION
COPY
Certification

Tehama Wireless Design Group Inc.
2607 7th st Suite G
Berkeley, CA 94710
United States
  Date of Grant: 06/30/2019

Application Dated: 06/30/2019
 
Attention: James Orton , President

NOT TRANSFERABLE
EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below.
 
FCC IDENTIFIER:  TS4-TW223
Name of Grantee:  Tehama Wireless Design Group Inc.
Equipment Class: Digital Transmission System
Notes: RPT TW223
Modular Type: Does not apply
Grant Notes  FCC Rule Parts Frequency
Range (MHZ)
Output
Watts
Frequency
Tolerance
Emission
Designator
15C 906.0  -  924.0 0.061944  

Power output listed is conducted. The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.



Mail To: