FCC ID XWX-LOS5000B
Real Time Location Sensor
by Zebra Technologies Corporation
Grantee Code: XWX Product Code: LOS5000B
Latest application date: 2014-05-29
FCC ID Device Details
Operating Frequencies
| Frequency Range | Application Purpose | Final Action Date |
|---|---|---|
| 2441.8 MHz | Original Equipment | 2014-05-29 |
Exhibits
| Document | Type | Available | File |
|---|---|---|---|
| Manual DRAFT | Users Manual | 2014-05-29 | PDF 1.8 MB |
| Int | Internal Photos | 2014-05-29 | PDF 327.4 KB |
| Ext | External Photos | 2014-05-29 | PDF 759.9 KB |
| Label | ID Label/Location Info | 2014-05-29 | PDF 468.6 KB |
| Setup | Test Setup Photos | 2014-05-29 | PDF 354.5 KB |
| DTS | Test Report | 2014-05-29 | PDF 1.7 MB |
| Authorization | Cover Letter(s) | 2014-05-29 | PDF 373 KB |
| Confid | Cover Letter(s) | 2014-05-29 | PDF 620.6 KB |
| RFx | RF Exposure Info | 2014-05-29 | PDF 24.4 KB |
| Block Metadata only | Block Diagram | PDF 185 KB | |
| Schema Metadata only | Schematics | PDF 2.2 MB | |
| Ops Metadata only | Operational Description | PDF 12.9 KB | |
| Parts Metadata only | Parts List/Tune Up Info | PDF 66.5 KB |
Application Information
| Application ID | HrfoL+oVJYMdb0RMrjPdlQ== |
|---|---|
| Final Action Date | 2014-05-29 |
| Application Purpose | Original Equipment |
| Applicant FRN | 0019283688 |
| Model | LOS5000B |
| Frequency Range | 2441.8 MHz |
| Equipment Class | DTS - Digital Transmission System |
| Device Description | Real Time Location Sensor |
| Responsible Party | Qianlin Zhou, Regulatory Specialist, larry.zhou@zebra.com  , 346-260-3543 |
| Technical Contact | Gordon Hurst, MiCOM Labs, certification@micomlabs.com  , (925)4620304 |
| Test Firm | Gordon Hurst, MiCOM Labs, gordon_hurst@micomlabs.com , 925-462-0304 |
| TCB Email | certification@micomlabs.com |
| TCB Scope | A4: UNII devices & low power transmitters using spread spectrum techniques |
| Short-Term Confidentiality | No |
| Long-Term Confidentiality | Yes |
| Grant Deferral | No |
| Modular Equipment | Does not apply |
| Composite Device | No |
| Composite Part | No |
| Cognitive Radio | No |
| Authorization Waiver | No |
| Authorization Waiver Approved | No |
| Section 5301 Certification | Yes |
| Related OET Knowledge DataBase Inquiry | No |
| Grant Comments | Power Output listed is Conducted. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance |
Applications
| Application ID | Date | Purpose |
|---|---|---|
| HrfoL+oVJYMdb0RMrjPdlQ== | 2014-05-29 | Original Equipment |
Grants
TCB Grant - Application HrfoL+oVJYMdb0RMrjPdlQ==
| TCB | GRANT OF EQUIPMENT AUTHORIZATION |
TCB |
| Certification | ||
| Issued Under the Authority of the | ||
| Federal Communications Commission | ||
| By: |
|
MiCOM Labs 575 Boulder Court Pleasanton, CA 94566 |
Date of Grant: 05/29/2014 Application Dated: 05/29/2014 |
| Zebra Technologies Corporation |
| 3 Overlook Point |
| LINCOLNSHIRE, IL 60069 |
| Attention: Qianlin Zhou , Regulatory Specialist |
| NOT TRANSFERABLE |
| EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below. |
| FCC IDENTIFIER: | XWX-LOS5000B |
| Name of Grantee: | Zebra Technologies Corporation |
| Equipment Class: | Digital Transmission System |
| Notes: | Real Time Location Sensor |
| Grant Notes | FCC Rule Parts | Frequency Range (MHZ) | Output Watts | Frequency Tolerance | Emission Designator |
| 20 | 15C | 2441.8 - 2441.8 | 0.052 |
| Power Output listed is Conducted. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance |
| 20: | All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed. |
EAS Grant - Application HrfoL+oVJYMdb0RMrjPdlQ==
| COPY |
FEDERAL COMMUNICATIONS COMMISSION WASHINGTON, D.C. 20554 GRANT OF EQUIPMENT AUTHORIZATION |
COPY |
| Certification |
|
Zebra Technologies Corporation 3 Overlook Point LINCOLNSHIRE, IL 60069 United States |
Date of Grant: 05/29/2014 Application Dated: 05/29/2014 |
| Attention: Qianlin Zhou , Regulatory Specialist |
| NOT TRANSFERABLE |
| EQUIPMENT AUTHORIZATION is hereby issued to the named GRANTEE, and is VALID ONLY for the equipment identified hereon for use under the Commission's Rules and Regulations listed below. |
| FCC IDENTIFIER: | XWX-LOS5000B |
| Name of Grantee: | Zebra Technologies Corporation |
| Equipment Class: | Digital Transmission System |
| Notes: | Real Time Location Sensor |
| Modular Type: | Does not apply |
| Grant Notes | FCC Rule Parts | Frequency Range (MHZ) | Output Watts | Frequency Tolerance | Emission Designator |
| 20 | 15C | 2441.8 - 2441.8 | 0.052 |
| Power Output listed is Conducted. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter within a device, except in accordance with accepted multi-transmitter product procedures. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance |
| 20: | All electrical and mechanical devices employed for spurious radiation suppression, including any modifications made during certification testing, must be incorporated in each unit marketed. |
| Mail To: |